ospfd [ -dhlv ] [ -f config-file ] [ -i pid-file ] [ -P port-number ]
ospfd is a routing component that works with the zebra routing engine.
Runs in daemon mode, forking and exiting from tty.
-f, --config-file config-file
Specifies the config file to use for startup. If not specified
this option will likely default to /usr/local/etc/ospfd.conf.
A brief message.
-i, --pid_file pid-file
When ospfd starts its process idenifier is written to pid-file.
The init system uses the recorded PID to stop or restart ospfd.
The likely default is /var/run/ospfd.pid.
Turn verbose logging on.
-P, --vty_port port-number
Specify the port that the ospfd VTY will listen on. This
defaults to 2604, as specified in /etc/services.
Print the version and exit.
router zebra -- (Move routes into kernel table)
network [NETWORK] area [OSPF-AREA-ID]
no network [NETWORK]
show ip ospf interface
The default location of the ospfd binary.
The default location of the ospfd config file.
If the ospfd process is config'd to output logs to a file, then
you will find this file in the directory where you started
This man page is intended as a quick reference for command line
options, and for config file commands. The definitive document is the
Info file zebra.
The ospfd process may log to standard output, to a VTY, to a log file,
or through syslog to the system logs. ospfd supports many debugging
options, see the Info file, or the source for details.
References to other related man pages:
ripd(8), ripngd(8), ospf6d(8), bgpd(8), zebra(8), vtysh(1)
ospfd eats bugs for breakfast. If you have food for the maintainers try
See <www.zebra.org>, or the Info file for an accurate list of authors.
Zebra Beast - OSPFD July 2000 OSPFD(8)
Man(1) output converted with