ospf6d [ -dhv ] [ -f config-file ] [ -i pid-file ] [ -P port-number ]
ospf6d is a routing component that works with the zebra routing engine.
Runs in daemon mode, forking and exiting from tty.
-f, --config-file config-file
Specifies the config file to use for startup. If not specified
this option will likely default to /usr/local/etc/ospf6d.conf.
A brief message.
-i, --pid_file pid-file
When ospf6d starts its process idenifier is written to pid-file.
The init system uses the recorded PID to stop or restart ospf6d.
The likely default is /var/run/ospf6d.pid.
-P, --vty_port port-number
Specify the port that the ospf6d VTY will listen on. This
defaults to 2606, as specified in /etc/services.
Print the version and exit.
router zebra -- (Move routes into kernel table)
network [NETWORK] area [OSPF6-AREA-ID]
no network [NETWORK]
show ip ospf6 interface
show ip ospf6 neighbor
show ip ospf6 database
show ip ospf6 route
The default location of the ospf6d config file.
If the ospf6d process is config'd to output logs to a file, then
you will find this file in the directory where you started
This man page is intended as a quick reference for command line
options, and for config file commands. The definitive document is the
Info file zebra.
The ospf6d process may log to standard output, to a VTY, to a log file,
or through syslog to the system logs. ospf6d supports many debugging
options, see the Info file, or the source for details.
References to other related man pages:
ripd(8), ripngd(8), ospfd(8), bgpd(8), zebra(8), vtysh(1)
ospf6d eats bugs for breakfast. If you have food for the maintainers
See <www.zebra.org>, or the Info file for an accurate list of authors.
Zebra Beast - OSPF6D July 2000 OSPF6D(8)
Man(1) output converted with