bgpd [ -dhpPv ] [ -f config-file ] [ -i pid-file ] [ -p bgp-port-number
       ] [ --bgp_port=port-number ] [ -P vty-port-number ]


       bgpd is a routing component that works with the zebra routing engine.


       -d, --daemon
              Runs in daemon mode, forking and exiting from tty.

       -f, --config-file config-file
              Specifies the config file to use for startup. If  not  specified
              this option will likely default to /usr/local/etc/bgpd.conf.

       -h, --help
              A brief message.

       -i, --pid_file pid-file
              When  bgpd  starts its process idenifier is written to pid-file.
              The init system uses the recorded PID to stop or  restart  bgpd.
              The likely default is /var/run/

       -p, --bgp_port=port
              Set the port that bgpd will listen to for bgp data.

       -P, --vty_port port-number
              Specify the port that the bgpd VTY will listen on. This defaults
              to 2605, as specified in /etc/services.

       -r, --retain
              When the program terminates, retain routes added by bgpd.

       -v, --version
              Print the version and exit.


        router zebra  -- (Move routes into kernel table)
        router bgp [AS-NUMBER]
        neighbor [PEER-IP-ADDRESS] route-map [in | out]
        neighbor [PEER-IP-ADDRESS] distribute-list [in | out]
        neighbor [PEER-IP-ADDRESS] next-hop-self
        neighbor [PEER-IP-ADDRESS] weight [WEIGHT]
        neighbor [PEER-IP-ADDRESS] default-originate
        neighbor [PEER-IP-ADDRESS] ebgp-multihop

        neighbor [PEER-IP-ADDRESS] shutdown
        no neighbor [PEER-IP-ADDRESS] shutdown

        clear ip bgp [PEER-IP-ADDRESS]

        show ip bgp [NETWORK]
        show ip bgp reg-exp [AS-REGEXP]
        show ip bgp summary
        show ip bgp neighbor [PEER-IP-ADDRESS]
        show ip bgp route

        show debug

        debug bgp
        debug event
        debug update
        debug keepalive

        no debug event
        no debug update
        no debug keepalive


              The default location of the bgpd binary.

              The default location of the bgpd config file.

              If the bgpd process is config'd to output logs to a  file,  then
              you will find this file in the directory where you started bgpd.


       This man page is  intended  as  a  quick  reference  for  command  line
       options,  and  for config file commands. The definitive document is the
       Info file zebra.


       bgpd eats bugs for breakfast. If you have food for the maintainers  try


       See  <>, or the Info file for an accurate list of authors.

Zebra Beast - BGPD                 July 2000                           BGPD(8)

Man(1) output converted with man2html